Chevron Marine Lubricants takes temperature of 2020 fuel switch

After over half a year of low-sulphur fuel operations for international shipping, Chevron Marine Lubricants has distilled its experiences of working with new fuels and lubricants into a new whitepaper published today.

Chevron Marine Lubricants takes temperature of 2020 fuel switch
Photo: Chevron

‘Taking the Temperature of the 2020 fuel sulphur switch’ includes findings based on work with ship operators worldwide to manage the transition from traditional high-sulphur fuel oil (HSFO) to very low-sulphur fuel oil (VLSFO) – the most widely used means of complying with IMO’s 2020 regulation. The paper also explores what these experiences mean for shipping as it prepares for even greater changes in the future, as decarbonisation and other sustainability targets further influence fuel choices.

Ian Thurloway, Brand, Marketing and Business Development Manager for Chevron Marine Lubricants, says:

“Chevron’s observations show that most ship operators managed the transition very well. Fuel quality has been less variable than expected and accurate recommendations on cylinder lubrication helped prevent the worst fears from being realised. But there have been engine condition concerns and rigorous monitoring remains a fundamental of any fuel change – particularly faced with a whole new range of clean fuels to choose from.”

Chevron notes in the whitepaper that VLSFO in general has a higher energy content than HSFO, offering good value for users. But its rapid ignition has caused problems for some older engines. Meanwhile the practice of flushing high-sulphur residues from tanks ahead of the regulation’s entry into force also contributed to an increase in cylinder condition challenges early in the year.

The lower sulphur content in marine fuel also reduces the safety margin between normal piston running, with a limited but manageable level of corrosion, and damaging abrasive or adhesive wear. To detect these conditions before they lead to irreversible engine damage Chevron recommends that operators employ a robust onboard drip oil monitoring programme, supported by frequent onshore laboratory analysis. Chevron’s own DOT.FAST® service now includes a separate indicator for abrasive/adhesive wear in its onshore laboratory analyses.

Luc Verbeeke, Senior Engineer, Chevron Marine Lubricants, says:

“Ship operators can use the DOT.FAST® onboard kit to check if total iron in the drip oil rises. The deeper laboratory analysis then identifies if the drip oil contains greater levels of magnetic iron particles. This would indicate abrasive/adhesive wear, meaning that operators should adjust either the base number or the feed rate of their cylinder lubricant.”